Hadley 1,2,3 or 4 Hole Pull Out Spot Resist Stainless Steel Faucet Deck with Soap Dispenser

Bought this faucet to replace one that was about 2 inches higher at the spout, and splashed water all over. My wife likes the high profile so I had to stay with that design, however, getting one that the spout was lower cuts down on the splashing to a tolerable level. My sink has the 3 hole design so I used the cover plate on the install. My biggest gripe is that with only the center nut holding the faucet in place, the ends of that plate stick up forcing me to apply caulking to keep water from leaking under the sink. The faucet I replaced had a bolt down design for that plate using the two other holes. Much better than this! The other issue I had is that the sink hole isn’t large enough to accommodate the faucets lines, so centering the faucet correctly was impossible. Wanted the handle to the right side and I couldn’t do it without cutting the sink hole out. So the handle is facing forward and still off center a bit. Other than those issues the faucet works fine.

Just bought and in stalled within 45 minutes to replace a competitors product that continuously caused issues with hot water flow despite free replacements over the past 2-3 years. We have used Moen in the past and are so glad we chose Moen for our kitchen

Super easy installation, and works fine. Like the power boost button as well. I really like the warranty on Moen products and have replaced cartridges after 20 years, so I’m happy to get a chance to use Moen for kitchen faucet.

When we remodeled our bathroom we used Moen. Our experience with those products made us immediately think Moen when replacing our kitchen sink faucet. They make great products that stand the test of time.

This faucet is great! Should I had known we were going to like it so much, I would've bought it way before. My wife is enjoying washing the dishes!