Duplex MMDVM UHF/VHF Board, OLED and Case, P25 DMR YSF, for Raspberry Pi Zero W 0W 2W 3B 4B

Supports DMR, P-25, D-Star and System Fusion

Fully tested. Onboard LED to show status (TX, RX, PTT, Mode)

Mounts cleanly on all current Raspberry Pi's including the Pi Zero W 2W/3B/4B

WIDELY COMPATIBLE: Supports DMR, P-25, D-Star and System Fusion

WORK with RASBERRY Pi: Mounts cleanly on current Raspberry Pi including the Pi Zero W 2W/3B/4B.Mode: Support both Duplex mode and Simplex mode

Differencs in Duplex and Simplex:in Duplex mode,have 2 time slots, and Tx and Rx can do at the same time

Radio Frequency : in duplex mode,support uhf 430-440MHZ, in simplex mode support both uhf 430-440MHz and vhf 140-150MHz

adjusted: TX =0, RX=0,need no offset.

Modem select: STM32-DVM/MMDVM_HS-Raspberry pi Hat(GPIO)

Aluminum alloy shell:High RF performace

LEDs:on board leds to show status, with status words on shell

How to write WiFi detail into the spot:

Method 1: Generate WiFi config file, and plug it into TF card.

We need a TF reader.Put our TF card into this TF reader and plug this into our computer.

Go tourl and then fill your WIFI name into the SSID, password into the PSK, click submit. Then the file "wpa_supplicant.conf" is generated. Drag this file into your TF card's boot path. And plug the card into your spot. Power up your spot, and wait for 1-2minutes.Then we go topi-starand play with the settings. Please keep this in mind that gadget only support 2.4 Gigahertz router, and it does not work with 5.8G router.

Colour:white+black

Material:PCB+electronic components+aluminum alloy

Package Contents:

1 x spot Board

1 x Shell with mounting screws

Only the above package content, other products are not included.

Note: Light reflection and different displays may cause the colour of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.