Shortwave Tuned Filter Amplifier, 3–30 MHz, 0–30 dB Gain, Transmit and Pass Modes

This unit is a receiving amplifier with a shortwave tunable bandpass filter centre frequency, covering a frequency range of 3-30MHz, and an adjustable gain of 0-30dB.

Signals from the ANT interface are filtered by the built-in shortwave tunable narrowband filter, amplified by a low-noise amplifier, and then sent to the RX/TX interface.

The bandwidth of the tunable narrowband filter is approximately 1MHz. Adjusting the filter knob to reach the target frequency allows the signal at that frequency to pass through, while other frequency signals on either side are attenuated. The filtered signal is then amplified by the low-noise amplifier, whose gain is adjustable. Adjusting the gain to a suitable level based on the strength of the received signal and the dynamic range of the device prevents receiver overload.

Built-in relay allows transmission even when powered off or connected to the PTT signal line. Maximum withstand voltage is AC 440V/DC 120V, maximum withstand current is 8A. Please use below the maximum withstand voltage and current.

For both transmission and reception, please turn off the amplifier before transmitting or connect the PTT signal line to the amplifier to control the internal relay switch.

Colour: Dark

Material: Aluminum Alloy

Package Contents:

1*Shortwave tuned Filter amplifier

Only the above package content, other products are not included.

Note: Light reflection and different displays may cause the colour of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.